Lock iconRectangle 1Rectangle 2 + Rectangle 2 CopyShapeRectangle 1


  • Sale
  • $71

This kit is designed to be installed inline with your stock low pressure fuel pump (LPFP), provides approximately 50% more flow over stock, and can be purchased with or without the pump.

  • Complete inline upgrade:
    • Is a complete install kit that also includes the Walbro GSL392 pump, comes fully assembled, and ready to install with your stock LPFP.

  • Inline install only kit:
    • This is a complete install kit for your Walbro GSL392 pump and does not include any pumps. 

  • Both options include the following:
    • SAE J30R10 E85 compatible fuel line
    • 14ga fuel resistant wiring harness
    • Quick connect female bullet connectors (2)
    • Vent tube replacement clip
    • Nylon cable ties (10)
    • Stainless steel lock nuts (2)
    • CD with installation instructions
    • Ethanol tester to verify your ethanol content
    • 10ga/14ga stepdown butt splices w/E85 compatible heatshrink (2)
    • Pushlock pump retention fittings (2)
    • 14ga butt connectors w/heatshrink for pump removal to return to stock if/when desired (2)
  • Recommended accessories:
    • Lock Ring Removal Tool 

  • A preview of the installation guide for these kits can be found by clicking this link: Installation guide

*Note:  Walbro does not warranty this pump for E85 use.  If your application requires an E85 certified pump you may want to consider selecting a Stage 2 fuel kit.

** IMPORTANT:  Do NOT attempt to run this kit inline with our Stage 2 kit.  The Stage 2 kit is a higher flowing kit and this will not only restrict the flow of the stage 2 kit, it will result in failures.